Archgard Optima 32-1 Specifications download pdf (Page 12)

Optima 32 - 1 12

Instructions for use with Archgard vertical termination cap. Part # TK-40/32.

Install the termination cap being sure to provided sufficient space (around and on top) so as not

to impede the flow of air, both into and out of the cap. This cap is only to be used for non com-

bustible installations. Do not recess into the top of the chimney.

1. Mark each end of one liner with “Air Intake”.

2. Mark each end of the second liner with “Exhaust”.

3. Pull the liner through the chimney.

4. Install the flashing. Do Not bend or cut the flashing in any way.

5. Seal and attach the liner marked “Air Intake” to the vent terminal pipe marked “Air Intake” with the collar

clamp provided.

6. Seal and attach the liner marked “Exhaust” to the vent terminal pipe marked “Exhaust” with the collar clamp

provided.

7. Seal and attach the end of the flex marked “Air Intake” to the collar marked “Air Intake” on the appliance

with the collar clamp provided with the unit.

8. Install the exhaust vent restrictor provided with the unit on Natural Gas appliances with 20’ (6.1 M) and

above vent height installations ONLY Seal and attach the end of the flex marked “Exhaust” to the collar

marked “Exhaust” on the appliance with the collar clamp provided with the unit..

10. Caulk all joints as usual.

NOTE: The vertical termination cap must be sealed to the liner with suitable high temperature sealant and with the

hose clamps fasteners provided. The liners must form a complete connection from the appliance flue collars to the

vertical termination cap.

VENTING INSTRUCTIONS TK-40/32

The minimum flue (chimney) size required to run the two 3” (76 mm) is 4” x 7” (100 mm X 178 mm)

Front view of

DV Insert

Air Intake

Collar

Exhaust

Collar

3” (76 mm)

Flex Liner

Fresh Air

Intake

Min. vent height 8’ (2.44 M)

Max. vent height 35’ (10.6 M)

Vertical Termination

cap Part # TK-40/32

Place Vent Restrictor

in the position shown

(on the exhaust collar

before attaching the

Flex Liner) ONLY

when operating with

NATURAL GAS with a

VENT OF up to

20’ (6.1 m) restrictor

#1 AND 20’ (6.1 m)

ABOVE restrictor #2

Note Vent restrictor # 1 is the

item with the notch (restrictor #

2 shown in picture

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 40 41

Comments to this Manuals

No comments

Archgard Optima 32-1 Specifications Page 12

Comments to this Manuals

Related products and manuals for Fireplaces Archgard Optima 32-1