Archgard Optima 32-1 Specifications download pdf (Page 28)

Optima 32 - 1 28

Before servicing, read the terms and conditions of the Archgard warranty at the back of the

manual. Contact the authorized Archgard dealer where you purchased the appliance from and

provide them with details of the problem, together with the initial installation information (from

the back of this manual).

WARNING: Servicing of this appliance must be conducted by a qualified service

technician. Improper servicing, adjustment or alteration of this appliance may

cause property damage, personal injury or loss of life. All servicing should be

conducted with the appliance cold. All replacement parts must be authorized by

Archgard for suitability.

Note: the Shutter is set at the factory and normally only requires resetting at higher altitudes.

Caution: Wear gloves when adjusting the primary air with the appliance hot.

1. Open the lower grills.

2. Unscrew the 2 screws holding the control panel and remove the panel.

3. The primary air adjustment wing nut is located behind and to the left of the control valve.

4. Loosen the wing nut and slide the primary air shutter to the right to increase primary air

and to left to reduce primary air.

5. Tighten the wing nut after adjustment.

ADJUSTING PRIMARY AIR

SERVICING UNDER WARRANTY

INCREASE DECREASE

ADJUSTMENT WING NUT

ORIFICE CAP

ORIFICE CENTERING BRACKET

ELBOW FITTING

PRIMARY AIR SHUTTER

Air Shutter (side view)

Fig. 1.

Control Panel

Two Screws

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 40 41

No comments

Archgard Optima 32-1 Specifications Page 28