Archgard Optima 32-1 Specifications download pdf (Page 29)

Optima 32 - 1 29

ADJUSTING PRIMARY AIR

NOTE: Fig. 1. Is to give an example of what is a correct or incorrect flame pattern. It is not a

true representation of what the Optima 32-1 will look like in your home environment.

FLAMES...

The left side shows

correct adjustment. The

right side shows yellow

sooty flames requiring

increase in shutter open-

ing or cleaning of shutter

area due to lint buildup.

Fig.1

CHANGING MAIN BURNER ORIFICE

1. Remove the glass door. Follow GLASS DOOR REMOVAL instructions within this manual.

2. Locate & slide the Primary Air Sleeve fully toward the left. This will allow the sleeve to

disconnect from the burner tube. Follow ADJUSTING PRIMARY AIR instructions within this

manual for reassembly.

3. Remove the logs from the FiberFlame bed. See LOG PLACEMENT for instructions.

4. Remove the two screws holding the log rest to remove it.

5. Unscrew the two mounting screws that are located at the back rear of the ember bed.

6. Carefully remove the ember bed by using your index fingers in the holes and carefully lift the

ember bed (burner) out.

7. Use a 1/2” (13 mm) wrench to remove the orifice cap.

8. Change the orifice cap to the fuel type desired. Use a small quantity of gas thread seal

compound. Do not overtighten.

9. Reverse steps 6 to 1.

WARNING: When replacing the ember bed using the two screws, you MUST not over-

tighten the screws. Leave the screws “FINGER-TIGHT” allowing the ember bed to “float”.

This is required for expansion & contraction of the ember bed.

THIS APPLIANCE IS EQUIPPED FOR NATURAL GAS. An additional CONVERSION kit is required to

convert for Propane use. To order the CONVERSION kit, please contact your Authorized Archgard

Dealer.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 40 41

No comments

Archgard Optima 32-1 Specifications Page 29