Archgard Optima 45 - 3 Specifications download pdf (Page 22)

OPTIMA PS1 PELLET STOVE 22

THERMOSTAT / MANUAL Switch:

Selects the pellet stove operating mode. Slide the switch to MANUAL (the far right position) to

operate in user manually selectable heat level and controls. If you have a thermostat attached

and wish to have the pellet stove controlled by the device, slide the switch to HIGH/LOW (the

middle position) to operate the pellet stove in a modulating heat mode, where the thermostat

will control the heat output of the pellet stove, alternate between the lowest heat level and the

higher heat level pre-selected by the user. The ON/OFF setting (the far left position) is similar

to the previous mode, except that the stove will alternate between shutdown (stove turn

completely off) and restart to user selected heat level setting when commanded by the

thermostat. When using the thermostat, the HIGH/LOW mode is recommended. This setting

provides a more even heat output for better comfort and will extend the life of the ignition

system components. In addition, the constant visual of the flames in the stove will serve as

warning for people and pets to keep away from the stove during operations, rather then being

startled by spontaneous start-up of the stove. After switching modes, the stove should be

turned OFF and ON to reset the controls to operate in the new mode setting.

A SPST wall switch or remote control with passive on and off contact may also be used in

place of the thermostat for remote operation of the pellet stove.

ON/OFF Button:

Used to turn the stove ON and OFF.

If the stove is cold during start-up, to turn the pellet stove on, press and release the ON/OFF

button. The green light above the ON/OFF button will flash to indicate start-up cycle has

started. Fuel pellets will start to feed into the burn pot. The electric ignition system will be

automatically activated. Flames in the burn pot will appear in 3 to 7 minutes. Once the flame is

well established, the start-up cycle will end. This takes about 10 minutes. At this point, the user

will be able to make heat level adjustments in the manual mode, or the stove will carry on being

controlled by the thermostat.

If the stove is warm at restart, the ON/OFF button must be pressed down and held for two

seconds or more, until the light above the ON/OFF button is lit. The start-up cycle for the pellet

stove will be initiated. The pellet stove will be able to be adjusted in the Manual after 10

minutes or carry on being controlled by the thermostat. If you are starting a new stove or refilled

a completely empty hopper, see FUEL FEED button function below.

HEAT OUTPUT Button:

When the button is pressed, it will increase the heat output one heat level. Keep pressing the

button will cycle the heat level from 1 to 5 and back again. The convection fan speed will also

change according to the heat level. When the ON/OFF light is flashing during the start-up cycle,

the heat output button will cycle the heat level, but the stove will not respond to adjustments.

When the ON/OFF light is solid, indicating the start-up cycle has ended (about 10 minutes),

then the stove will respond, and only in manual mode. If it is a warm start-up, the ON/OFF light

will not flash indicating a start-up cycle. The stove will respond to heat adjustments only after

10 minutes from start-up.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 39 40

No comments

Archgard Optima 45 - 3 Specifications Page 22