Archgard Optima 45 - 3 Specifications download pdf (Page 34)

OPTIMA PS1 PELLET STOVE 34

PROBLEM CAUSE CURE

Glass is Dirty

(A light white/tan accumulation is

normal)

1. Need more combustion air. Push combustion air control knob in.

2. Burn pot is clogged Clean out burn pot and poke out

clogged air holes.

3. Poor fuel Change to dry clean fuel. Use higher

quality premium pellet fuel.

4. Clogged venting system. Check for blockage in the venting

system. Check vent cap and ash

clean-out Tee.

5. Clogged combustion air inlet or

inlet pipe.

Check for blockage in the air intake

connector and duct..

6. Excessive negative pressure in

the room.

Balance pressure in the room by

opening a window.

7. Clogged exhaust blower or

exhaust passages.

Conduct ash removal maintenance.

8. Defective exhaust blower. Check for proper voltage to the stove.

If the blower runs very slow, replace

blower.

Flame Goes Out on Low or

Won't Burn Overnight On Low.

The Heat Level #3 light will flash

on the control panel to indicate

that the Proof of Fire sensor has

tripped.

1. Burn pot is clogged. Clean out burn pot and poke out

clogged air holes.

2. Not high enough pellet fuel

feed rate.

Use the LOW ADJUST button to

increase fuel feed on heat setting 1.

Select heat setting #1. Press the LOW

ADJUST button until both heat setting

1 and 4 light is lit.

3. Poor fuel Change to dry clean fuel. Use higher

quality premium pellet fuel. Increase

fuel feed rate on low by using the

LOW ADJUST button as above.

4. Combustion air set too high Gradually restrict combustion air by

pulling the control knob out.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

Comments to this Manuals

No comments

Archgard Optima 45 - 3 Specifications Page 34

Comments to this Manuals

Related products and manuals for Stoves Archgard Optima 45 - 3