Archgard Optima 45 - 3 Specifications Page 4

  • Download
  • Add to my manuals
  • Print
  • Page
    / 40
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 3
OPTIMA PS1 PELLET STOVE 4
4
IMPORTANT SAFETY NOTES
When installing your stove, particular attention should be paid to fire
protection. If this room heater is not properly installed, a house fire may result.
To reduce the risk of fire, follow the installation instructions. Contact local
building, fire officials or authority having jurisdiction about restrictions,
installation inspection and permit requirements in your area.
CAUTION: Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal
lighter fluid, or similar liquids to start or “freshen up” a fire in this heater. Keep
all such liquids well away from the heater while it is in use.
DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS SUCH AS GASOLINE,
NAPHTHA OR ENGINE OIL.
Do not store any fuel closer than 2 feet from your unit. Do not place wood,
paper, furniture, drapes or other combustibles near the appliance.
RISK OF FIRE! Do not operate with stove door open.
WARNING! Never draw outside combustion air from a wall, floor or ceiling
cavity or from any enclosed space such as an attic or garage, carport or under
a mobile home.
Check your chimney system thoroughly when installing into an existing metal
or masonry chimney. Seek professional advice if in doubt about its condition.
Comply with all minimum clearances to combustibles as shown in this manual
for this appliance.
HOT WHILE IN OPERATION! Keep children, pets, clothing and furniture away.
Contact can cause skin burns.
All fuel burning appliances consume oxygen during operation. It is important
that you supply a source of fresh air to your unit while burning. A slightly
opened window is sufficient for this purpose. If you also have a fireplace in your
home, a downdraft may be created causing a draft down your chimney. Provide
adequate ventilation. This does not apply if the stove is installed with outside
combustion air connection.
The controls of your unit or the air supply passages should not be altered to
increase firing for any reason.
Do not permit soot or ash build-up in the venting system. Check and clean
venting system at regular intervals.
Cool ashes should be disposed of carefully, using a metal container.
Do not connect to any air distribution duct or system.
Do not connect this unit to a chimney flue already serving another appliance.
This appliance must be connected to a vent and terminate to the outside of the
building envelope. Never vent to another room or inside a building.
Do not operate if the gasket on the door is missing or damaged.
Do not operate with broken glass.
For further information refer to NFPA 211 (USA) or CAN/CSA-B365 (Canada).
Page view 3
1 2 3 4 5 6 7 8 9 ... 39 40

Comments to this Manuals

No comments