Archgard Optima 45 - 3 Specifications download pdf (Page 23)

OPTIMA PS1 PELLET STOVE 23

FAN HIGH Button:

Use this button to override the automatic fan speed control and turn the convection fan on high.

The smart control on this pellet stove will vary the fan speed in accordance with heat level

setting. It is best to let the controller adjust the speed of the fan for best efficiency and

minimized fan noise.

FUEL FEED Button:

This button manually activates the fuel feed auger. Press and hold this button will turn on the

auger to feed pellets into the burn pot.

When first using the pellet stove, or when you completely empty the hopper of pellets and

restarting after reloading the hopper, you can load the auger faster by pressing and holding this

button until you see pellets dropping into the burn pot. This button will turn off after one minute

and must be released and pressed again if you want to continue to manually activate the fuel

feed auger.

LOW ADJUST Button:

This button is used to change the fuel feed rates on the heat level 1 for various quality pellet

fuels. This button is used to keep the flames from extinguishing on heat level 1.

Push and release the LOW ADJUST button until the heat level 1 and 4 lights appear. This will

slightly increase the fuel feed rate on heat level 1. Push and release the button until the heat

level 1 and 3 lights appear, this will reduce the fuel feed rate on heat level 1. Use this setting

only if the operator has determined that the flames will stay on at this fuel feed rate. To return

to the default setting, push and release the button until just the heat level 1 light is on, this is a

general setting and will likely work with most types of fuels.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

No comments

Archgard Optima 45 - 3 Specifications Page 23